New powerline driven by 7XHR Reston Hornsby

One Lunger Talk!
Post Reply
Mechanix
Member QVEA
Reactions:
Posts: 4
Joined: Sat Sep 18, 2021 8:22 pm
Location: Marke
Name: Marnix Carlier
Contact:

New powerline driven by 7XHR Reston Hornsby

Post by Mechanix »

Hello to the Zagray Farm from Belgium,
We are making preparations to install an new powerline
driven by a Reston and Hornsby engine (40Hp) 7XHR
Last week the collegues did start up the engine again after 20 yaers.
Ath the second attempt, the engine was running again.
So now we can go on to make the preparations for the moving.
This is the storry of the actual preparation we do virtual on Fusion360,
to get know the probles we can encouter with the installarion
of the 7XHR engine, the new powerline and the DEMOOR P6 powerhammer

Mechanix
Member QVEA
Reactions:
Posts: 4
Joined: Sat Sep 18, 2021 8:22 pm
Location: Marke
Name: Marnix Carlier
Contact:

Re: New powerline driven by 7XHR Reston Hornsby

Post by Mechanix »

First of all we did draw a dummy engine Restom-Hornsby 7HXR
with fixationplates on to his concrete fundation:
engine block.png
concrete pate engine block.png
concrete block.png
concrete block with concrete plates.png
Concrete block with dummy engine vieuw 2.png

Mechanix
Member QVEA
Reactions:
Posts: 4
Joined: Sat Sep 18, 2021 8:22 pm
Location: Marke
Name: Marnix Carlier
Contact:

Re: New powerline driven by 7XHR Reston Hornsby

Post by Mechanix »

An other vieuw on the engine,
atachet on to his concrete block:
Concrete block with dummy engine.png
Als a detailed vieuw to the extra bearing atachement
outside the flying wheel and the power drive poully.
detail vieuw bearing block.png

Mechanix
Member QVEA
Reactions:
Posts: 4
Joined: Sat Sep 18, 2021 8:22 pm
Location: Marke
Name: Marnix Carlier
Contact:

Re: New powerline driven by 7XHR Reston Hornsby

Post by Mechanix »

The next thing we will have to do is to saw out the floor
on the good location to put in the concrete fundation for the engine:
dimentions concrete hole.png
concete hole made.png
After the concrete is hardet out, put in place the engine:
Dummy engine in place.png

Post Reply